Process Engineer
Bureau Veritas · Abu Dhabi, United Arab Emirates · On site · 3 days ago
Why a CV for this job?
- They see what they asked for, first. Your experience that matches the ad leads, in the ad's own words, so someone skimming finds it in seconds.
- It gets past the software. Many larger employers use software that ranks CVs by how closely they match the ad, often before anyone reads them.
- In the language of the ad. An ad written in Spanish gets a CV in Spanish, even when yours is in Portuguese.
- Your facts, nothing invented. Your own experience, reordered and reworded. What the ad wants and your CV does not show is listed for you to add, only if it is true. You check it before you send it.
Process Engineer /Process Design Engineer
Process design and engineering experience of 8 to 12+ years in Oil & Gas projects upstream projects, pipeline projects covering design, conceptual engineering, FEED, Detailed engineering.
Required Experience:
The candidate should have experience in preparing the following deliverables for Basic Engineering, FEED, or EPC projects with a reputed international EPC consultant.
Design Basis
Licensor Technology Evaluation
PFD and P&ID Preparation and or review for Urea Plant
HMB
Process data sheets, Equipment list, Line list, Load list, Tie-In list, Fluid list,
PSV Relief load estimation, PSV sizig
Flare sizing, KOD sizing
Pump sizing
Compressor Calculations, Anti surge design, settle out calculations etc
Steam generation and sizing calculations
Design of Separators, columns, Heat Exchangers, tanks
Hydraulic calculations, PSV sizing, Control valve sizing calculations
Interfacing with Piping, Mechanical Instrument engineers, Commissioning Engineers as required during the EPC stages
3D Model Review
vendor offer reviews
Experience across conceptual design, FEED, and detailed engineering phases.
Operation experience is not preferred.
Software/Technical Skills & Tools
- Experience with process simulation and engineering software such as HYSYS, PROMAX, Flare network analysis tools, and HTRI.
- Strong understanding of process design, sizing, and optimization techniques.
- Ability to critically review calculations and propose practical engineering solutions.
- Strong technical documentation and report-writing skills.
- Fluent in spoken and written English.
Education:
B tech Chemical Engineering / MTech Chemical Engineering
75% Marks in engineering are mandatory
Job Profile
Key Responsibilities
- Perform process design review and verification across conceptual, FEED, and detailed engineering stages.
- Prepare and review process design basis, philosophies, and engineering calculations.
- Review and verify Process Flow Diagrams (PFDs), Piping & Instrumentation Diagrams (P&IDs), and Heat & Material Balances (HMB).
- Review process datasheets, equipment lists, line lists, tie-in lists, fluid and load lists.
- Perform and review PSV relief load estimation and PSV sizing calculations.
- Review flare system calculations, knockout drum sizing, and associated hydraulics.
- Review pump, compressor, and rotating equipment process calculations including anti-surge and settle-out analyses.
- Review design of separators, columns, heat exchangers, tanks, and other process equipment.
- Perform hydraulic calculations and control valve sizing reviews.
- Interface with piping, mechanical, electrical, and instrumentation disciplines during EPC execution.
- Participate in 3D model reviews and vendor technical document reviews.
- Prepare and review technical reports, calculation notes, and design review comments.
- Ensure compliance with applicable international codes, standards, and project procedures.
- Site Visit: The candidate may be required to occasionally visit project sites to conduct audits or verification activities.
Location: Abu Dhabi, UAE
- Employer
- Bureau Veritas
- Location
- Abu Dhabi, United Arab Emirates · On site